Tag Archives: clipping

IQ, Raspberry Pi, Sensors

Pi HQ Cam Sensor Performance

13 Comments

Now that we know how to open 12-bit raw files captured with the new Raspberry Pi High Quality Camera, we can learn a bit more about the capabilities of its 1/2.3″ Sony IMX477 sensor from a keen photographer’s perspective.  The subject is a bit dry, so I will give you the summary upfront.  These figures were obtained with my HQ module at room temperature and the raspistill – -raw (-r) command:

Raspberry Pi
HQ Camera		raspistill
--raw -ag 1		Comments
Black Level256.3 DN256.0 - 257.3 based on gain
White Level4095Constant throughout
Analog Gain1Gain Range 1 - 16
Read Noise3 e-, gain 1
1.5 e-, gain 16		1.53 DN from black frame
11.50 DN
Clipping (FWC)8180 e-at base gain, 3400e-/um^2
Dynamic Range11.15 stops
11.3 stops		SNR = 1 to Clipping
Read Noise to Clipping
System Gain0.47 DN/e-at base analog gain
Star Eater AlgorithmPartly DefeatableAll channels - from base gain and from min shutter speed
Low Pass FilterYesAll channels - from base gain and from min shutter speed

Continue reading Pi HQ Cam Sensor Performance →

Color, Formats, Processing, Raspberry Pi, Sensors

Opening Raspberry Pi High Quality Camera Raw Files

17 Comments

The Raspberry Pi Foundation recently released an interchangeable lens camera module based on the Sony  IMX477, a 1/2.3″ back side illuminated sensor with 3040×4056 pixels of 1.55um pitch.  In this somewhat technical article we will unpack the 12-bit raw still data that it produces and render it in a convenient color space.

still life raw capture data file raspberry pi high quality hq cam f/8 1/2s base analog gain iso adobe rgb
Figure 1. 12-bit raw capture by Raspberry Pi High Quality Camera with 16 mm kit lens at f/8, 1/2 s, base ISO. The image was loaded into Matlab and rendered Half Height Nearest Neighbor in the Adobe RGB color space with a touch of local contrast and sharpening.  Click on it to see it in its own tab and view it at 100% magnification. If your browser is not color managed you may not see colors properly.

Continue reading Opening Raspberry Pi High Quality Camera Raw Files →

IQ, Sensors

Engineering Dynamic Range in Photography

Leave a comment

Dynamic Range (DR) in Photography usually refers to the linear working signal range, from darkest to brightest, that the imaging system is capable of capturing and/or displaying.  It is expressed as a ratio, in stops:

    \[ DR = log_2(\frac{Maximum Acceptable Signal}{Minimum Acceptable Signal}) \]

It is a key Image Quality metric because photography is all about contrast, and dynamic range limits the range of recordable/ displayable tones.  Different components in the imaging system have different working dynamic ranges and the system DR is equal to the dynamic range of the weakest performer in the chain.

Continue reading Engineering Dynamic Range in Photography →

IQ, Sensors

Determining Sensor IQ Metrics: RN, FWC, PRNU, DR, gain – 1

Leave a comment

We’ve seen how to model sensors and how to collect signal and noise statistics from the raw data of our digital cameras.  In this post I am going to pull both things together allowing us to estimate sensor IQ metrics: input-referred read noise, clipping/saturation/Full Well Count, Dynamic Range, Pixel Response Non-Uniformities and gain/sensitivity.

There are several ways to extract these metrics from signal and noise data obtained from a camera’s raw file.  I will show two related ones: via SNR in this post and via total noise N in the next.  The procedure is similar and the results are identical.

Continue reading Determining Sensor IQ Metrics: RN, FWC, PRNU, DR, gain – 1 →

IQ, Sensors

Sensor IQ’s Simple Model

Leave a comment

Imperfections in an imaging system’s capture process manifest themselves in the form of deviations from the expected signal.  We call these imperfections ‘noise’ because they introduce grain and artifacts in our images.   The fewer the imperfections, the lower the noise, the higher the image quality.

However, because the Human Visual System is adaptive within its working range, it’s not the absolute amount of noise that matters to perceived Image Quality (IQ) as much as the amount of noise relative to the signal – represented for instance by the Signal to Noise Ratio (SNR). That’s why to characterize the performance of a sensor in addition to signal and noise we also need to determine its sensitivity and the maximum signal it can detect.

In this series of articles I will describe how to use the Photon Transfer method and a spreadsheet to determine basic IQ performance metrics of a digital camera sensor.  It is pretty easy if we keep in mind the simple model of how light information is converted into raw data by digital cameras:

Sensor photons to DN A
Figure 1.

Continue reading Sensor IQ’s Simple Model →

Exposure, IQ, Sensors, Uncategorized

How to Measure the SNR Performance of Your Digital Camera

1 Comment

Determining the Signal to Noise Ratio (SNR) curves of your digital camera at various ISOs and extracting from them the underlying IQ metrics of its sensor can help answer a number of questions useful to photography.  For instance whether/when to raise ISO;  what its dynamic range is;  how noisy its output could be in various conditions; or how well it is likely to perform compared to other Digital Still Cameras.  As it turns out obtaining the relative data is a little  time consuming but not that hard.  All you need is your camera, a suitable target, a neutral density filter, dcraw or libraw or similar software to access the linear raw data – and a spreadsheet.

Continue reading How to Measure the SNR Performance of Your Digital Camera →